Whirlpool 8316473A Manuel D’Utilisation

■

A 240 volt, 50 Hz., AC only, 8 - 10-amp, fused electrical 
supply is required. A time-delay fuse or circuit breaker is 
recommended. It is recommended that a separate circuit 
serving only this appliance be provided. 

■

This washer is equipped with a power supply cord having an 
earthing plug.

■

To minimize possible shock hazard, the cord must be plugged 
into a mating, earthing-type outlet, earthed in accordance with 
local codes and ordinances. If a mating outlet is not available, 
it is the personal responsibility and obligation of the customer 
to have the properly earthed outlet installed by a qualified 
electrician.

■

If codes permit and a separate earth wire is used, it is 
recommended that a qualified electrician determine that the 
earth path is adequate.

■

Do not earth to a gas pipe.

■

Check with a qualified electrician if you are not sure the 
washer is properly earthed. 

■

Do not have a fuse in the neutral or earth circuit.

NOTE: To avoid floor damage, set the washer onto cardboard 
before moving across floor.

Removing the shipping strap is necessary for proper operation. If 
the shipping strap is not removed, the washer will make excessive 
noise. 
1. Move the washer to within approximately 90 cm (3 ft) of its 

final location.

2. The washer must be in the upright position and not tilted 

before removing the shipping strap.

3. Locate the yellow shipping strap on the rear of the machine 

near the bottom.  

For an earthed, cord-connected washer:
This washer must be earthed. In the event of a malfunction 
or breakdown, earthing will reduce the risk of electrical 
shock by providing a path of least resistance for electric 
current. This washer is equipped with a cord having an 
equipment-earthing conductor and an earthing plug. The 
plug must be plugged into an appropriate outlet that is 
properly installed and earthed in accordance with all local 
codes and ordinances.

Improper connection of the equipment-

earthing conductor can result in a risk of electric shock. 
Check with a qualified electrician or serviceman if you are in 
doubt as to whether the appliance is properly earthed.

Do not modify the plug provided with the appliance – if it will 
not fit the outlet, have a proper outlet installed by a qualified 
electrician.

For a permanently connected washer:
This washer must be connected to an earthed metal, 
permanent wiring system, or an equipment earthing 
conductor must be run with the circuit conductors and 
connected to the equipment-earthing terminal or lead on the 
appliance.

 

A