Whirlpool 3XWTW5705 Manuel D’Utilisation

Page de 36
8
6. Set the TEMPERATURE selector to the correct setting for the 
type of fabric and soils being washed. Use the warmest water 
safe for fabric. Follow garment label instructions.
Your washer uses automatic temperature control (on some 
models) to maintain a uniform water temperature by regulating 
the incoming hot and cold water. This helps eliminate 
undissolved detergent and ensures consistent cleaning 
results. The Hot and Warm settings on this washer will be 
cooler than you are accustomed to. Wash temperatures in this 
washer are lower than the temperatures you may be used to in 
conventional washers. 
NOTE: Make sure that both the hot and cold water taps are 
fully turned on, or the automatic temperature control feature 
will not work properly.  
NOTE: In wash water temperatures colder than 15.6ºC, 
detergents do not dissolve well. Soils can be difficult to 
remove. Some fabrics can retain wear wrinkles and have 
increased pilling (the formation of small lint-like balls on the 
surface of garments).
7. (OPTIONAL) Some models have an EXTRA RINSE selector. 
For an additional rinse and spin at the end of a wash cycle, 
set the EXTRA RINSE selector to ON. On some models, the 
Extra Rinse feature is part of the cycle. 
8. (OPTIONAL) Some models have an END OF CYCLE SIGNAL 
selector. Set the END OF CYCLE SIGNAL selector to ON if you 
want your washer to alert you when the wash cycle is complete. 
The signal is helpful when you are washing items that should be 
removed from the washer as soon as the cycle ends.
9. Push in the Cycle Control knob and turn it clockwise to the 
wash cycle you want. Reduce the wash time when using a 
small load size setting. See “Selecting a Cycle and Time.”
Pull out the Cycle Control knob to start the washer.
To stop or restart your washer
To stop the washer at any time, push in the Cycle Control 
knob. 
To restart the washer, close the lid (if open) and pull out 
the Cycle Control knob.
Adding bleach to models without a bleach dispenser
If desired, add measured liquid chlorine bleach after the washer 
starts agitating. Pour diluted bleach around the agitator, not 
directly onto the load. Undiluted bleach will damage any fabric it 
touches. See “Adding Liquid Chlorine Bleach.”
Adding softener to models without a fabric softener 
dispenser
If desired, add measured liquid fabric softener to the final rinse 
water. Always dilute fabric softener with 125 to 250 mL of warm 
water. Undiluted fabric softener can stain fabrics. See “Adding 
Liquid Fabric Softener.”
Washer Symbols
The control panel of your washer contains symbols. Refer to the 
chart below for a definition of those symbols.
Water Temp
Use For
Hot
Whites and pastels
Heavy soils
Warm
Bright colors
Moderate to light soils
Cold
Colors that bleed or fade
Light soils
Symbols
Symbols
Small Load
Hand Washables
Large Load
Super Wash
Cold
Temperature
Wash
Warm
Temperature
Quick Wash
Hot
Temperature
Prewash
Temperature
Rinse
On
Extra Rinse
Off
Spin
Buzzer
Slow Spin
Cotton
Cool Down
Synthetics
Pull Start
Push Stop
Delicates