Impex STB-70105 Manuel Du Propriétaire
©IMPEX INC. www.impex-fitness.com
6
IMPORTANT ASSEMBLY INFORMATION
Tools required for assembling the bench: adjustable wrench and Allen wrench.
NOTE: It is strongly recommended that this equipment be assembled by two or more
people to avoid possible injury.
people to avoid possible injury.
Ensure Carriage Bolts are inserted through the SQUARE holes on components that need to
be assembled. Attach washer only to end of the Carriage Bolt.
be assembled. Attach washer only to end of the Carriage Bolt.
Use Allen Bolts or Hex Bolts inserted through the ROUND hole on components that need to
be assembled.
be assembled.
Always wait until all bolts are assembled onto the bench before tightening the bolts. Do not
tighten each bolt right after it is installed
tighten each bolt right after it is installed
Fasten Nuts and Bolts
Securely tighten all nuts and bolts after all
components have been assembled in current and
previous steps.
NOTE: Do not over tighten any component with
pivoting function.
Make sure all pivoting components are able to move
freely.
components have been assembled in current and
previous steps.
NOTE: Do not over tighten any component with
pivoting function.
Make sure all pivoting components are able to move
freely.
Do not tighten all nuts and bolts in this step.
CARE AND MAINTENANCE
1. Lubricate moving parts with WD-40 or light oil periodically.
2. Inspect and tighten all parts before using the equipment.
3. The equipment can be cleaned using a damp cloth and mild non-abrasive detergent.
2. Inspect and tighten all parts before using the equipment.
3. The equipment can be cleaned using a damp cloth and mild non-abrasive detergent.
DO NOT use solvents.
4. Examine the equipment regularly for signs of damages or wear.
5. Replace any defective components immediately and/or keep the equipment out of use until
5. Replace any defective components immediately and/or keep the equipment out of use until
repair.
6. Failure to examine regularly may affect the safety level of the equipment.
WEIGHT CAPACITY AND DIMENSION
1. Maximum weight on Bar Catch: 300 lbs.
2. Maximum weight on Weight Storage Post: 100 lbs
3. Bar Catch height ranges from 20” to 62 ½” with 13 positions and 3 ½” for each adjustment.
4. Assembled dimension (L x W x H): 49 ½” x 65” x 66 ½”.
2. Maximum weight on Weight Storage Post: 100 lbs
3. Bar Catch height ranges from 20” to 62 ½” with 13 positions and 3 ½” for each adjustment.
4. Assembled dimension (L x W x H): 49 ½” x 65” x 66 ½”.