Home Automation 10A11-1 Manuel D’Utilisation

Page 2

SPKR1 (SPEAKER #1 OUTPUT)

SPKR1 (SPEAKER #1 COMMON)

SPKR2 (SPEAKER #2 OUTPUT)

SPKR2 (SPEAKER #2 COMMON)

TWISTED PAIR

WITH SHIELD

TWISTED PAIR

8 OHM

SPEAKER

8 OHM

MODEL 10A11-1, REV C

TWO-WAY AUDIO/VOICE ALARM MODULE

TWO-WIRE
ELECTRET

MICROPHONE

ELECTRET

TWO-WIRE

33A00-4 CONSOLE,

33A00-20 KEYPAD, OR

28A00-1, 28A00-2,

MIC2 (MICROPHONE #2 COMMON)

MIC1 (MICROPHONE #1 COMMON)

MIC2 (MICROPHONE #2 INPUT)

MIC1 (MICROPHONE #1 INPUT)

SPEAKERS / MICROPHONES

HI-FI

PAGE

HI-FI

SOURCE 6

AUDIO IN

LINE OUT (LINE-LEVEL AUDIO OUTPUT)

PAGE OUT (PAGE OUTPUT)

Figure 1 - Speaker/Microphone Connections

MOUNTING

When mounting and connecting the Model 10A11-1, Rev C, power down the controller (AC and battery). Connecting the Model
10A11-1, Rev C board, while power is still applied to the controller, can damage the board, the controller, or both.

Mount the Model 10A11-1, Rev C to the upper right side of the enclosure using the supplied adhesive-backed resealable fasteners.

When connecting to an OmniLT, route the cable to the connector on the top of the board marked "J1". Plug the Model 10A11-1, Rev
C cable into "J1" on the controller. The red wire should be to the left of the connector (red wire to Pin 1) - See Figure 2.
Make sure that the connector is aligned with the pins on "J1".

When connecting to an Omni II, OmniPro II, Lumina, or Lumina Pro, route the cable along the top of the enclosure to the connector
on the left side marked "J2". Plug the Model 10A11-1, Rev C cable into "J2" on the controller. The red wire should be to the top of
the connector - See Figure 3.  Make sure that the connector is aligned with the pins on "J2".