Whirlpool CGT8000XQ Manuel De Montage

Selecting the proper location for your washer/dryer improves 

performance and minimizes noise and possible washer “walk.”
Your washer/dryer can be installed in a basement, laundry 

room, or recessed area. See “Drain System.”
Companion appliance location requirements should also be 

considered.
IMPORTANT: Do not install or store the washer/dryer where 

it will be exposed to the weather. Do not store or operate the 

washer/dryer in temperatures at or below 32°F (0°C). Some 

water can remain in the washer and can cause damage in low 

temperatures. Proper installation is your responsibility.
You will need:
n

   A water heater set to deliver 120°F (49°C) water to the 

washer.

n

   A grounded electrical outlet located within 6 ft. (1.8 m) of 

where the power cord is attached to the back of the washer. 

See “Electrical Requirements.”

n

      Hot and cold water faucets located within 4 ft. (1.2 m)  

of the hot and cold water fill valves, and water pressure  

of 20–100 psi (137.9–689.6 kPa).

n

   A level floor with a maximum slope of 1" (25 mm) under 

entire washer/dryer. Installing the washer/dryer on soft floor 

surfaces, such as carpets or surfaces with foam backing,  

is not recommended.

n

    A sturdy and solid floor to support the washer/dryer with  

a total weight (water and load) of 450 lbs (204 kg).

n

    A floor drain under the bulkhead. Prefabricated bulkheads 

with electrical outlets, water inlet lines, and drain facilities 

should be used only where local codes permit. 

n

    The location must be large enough to allow the washer and 

dryer doors to be fully opened.

n

    Additional spacing should be considered for ease of 

installation and servicing. The doors open more than 180°. 

The washer door is not reversible.

n

    Additional clearances might be required for wall, door, and 

floor moldings.

n

    Additional spacing of 1" (25 mm) on all sides of the washer/

dryer is recommended to reduce noise transfer.

n

    Companion appliance spacing should also be considered. 

Recessed Area Installation Instructions
This washer/dryer may be installed in a recessed area. For 

recessed area installations, minimum clearances can be found 

on the warning label on the rear of the dryer.
The installation spacing is in inches and is the minimum 

allowable. Additional spacing should be considered for ease 

of installation, servicing, and compliance with local codes and 

ordinances.
The dryer must be exhausted outdoors.