Whirlpool CGT8000XQ Manuel De Montage

4.  Models with separate washer power cords: Push the power 

cord plug into the opening on the right side of the rear panel 

and pull the power cord through the opening on the left side 

of the rear panel and close holes with the attached cap. Do 

not pull plug end of power cord through the right side hole.

NOTE: To avoid damage to internal washer parts or the 

power cord, if the cord does not pull out of the washer rear 

panel easily, do not force it. Remove the washer rear panel 

and guide the power cord around the obstruction and out 

the hole on the left side of the rear panel. 

5.  Close the bolt holes with the 4 transport bolt hole plugs.

IMPORTANT: If the washer/dryer is to be transported, call 

your product distributor or installer. To avoid suspension and 

structural damage, your washer/dryer must be properly set up 

for relocation by a trained professional.

NOTE: Slide washer/dryer onto cardboard or hardboard before 

moving to avoid damaging floor covering.

IMPORTANT: Position the washer/dryer so that the rear of 

the washer is within approximately 3 ft. (900 mm) of its final 

location.
There are 4 shipping bolts in the rear panel of the washer that 

support the suspension system during transportation. These 

bolts also retain the power cord inside the washer until the 

bolts are removed.

1.  Keep the washer/dryer in the upright position while removing 

the shipping bolts.

2.  Using a 1/2" (13 mm) wrench, loosen each of the bolts.

3.  Once the bolt is loose, move it to the center of the hole  

and completely pull out the bolt, including the plastic spacer 

covering the bolt. Once all 4 bolts are removed, discard  
the bolts and spacers.