Marvel ML24RAS1LS Manuel D’Utilisation

26

• Never attempt to repair or perform maintenance on 

the appliance until the main electrical power has been 

disconnected. Turning the appliance control "OFF" 

does not remove electrical power from the unit's wiring.

• Replace all parts and panels before operating.

If the appliance appears to be malfunctioning, read through 

this manual first. If the problem persists, check the trouble-

shooting guide below. Locate the problem in the guide and 

refer to the cause and its remedy before calling for service. 

The problem may be something very simple that can be 

solved without a service call. However, it may be required 

to contact your dealer or a qualified service technician.

Appliance not cold enough

(See “Adjusting the temperature" on 

page 11)

•  Control set too warm

•  Content temperature not stabi-

lized.

•  Excessive usage or prolonged 

door openings.

•  Airflow to front grille blocked.

 

•  Door gasket not sealing properly.

•  Adjust temperature colder. Al-

low 24 hours for temperature to 

stabilize.

•  Allow temperature to stabilize for 

at least 24 hours.

•  Airflow must not be obstructed to 

front grille. See “clearances” on 

       page 4.

•  Check door alignment and/or 

replace door gasket.

Appliance too cold

(See “Adjusting the Temperature” on 

page 11)

•  Control set too cold

•  Door gasket not sealing properly.

•  Adjust temperature warmer. 

       Allow 24 hours for temperature to 

      stabilize.

•  Check door alignment and/or 

replace door gasket.

No interior light.

•  Failed LED light assembly or light 

switch.

•  Contact a qualified service techni-

cian.

Light will not go out when door is 

closed

•  Display light is turned on. (Glass 

door models only.

•  Door not activating light switch.

•  Failed light switch

•  Turn off display light, shut door.

•  Appliance not level, level appli-

ance, (See page 4, “leveling legs”)

•  Verify the door is aligned properly, 

refer to page 25 for instructions.

•  Contact a qualified service techni-

cian.

Noise or Vibration

•  Appliance not level

•  Fan hitting tube obstruction.

•  Level appliance, see “Leveling 

Legs” on page 4.

•  Contact a qualified service techni-

cian.

Appliance will not run.

•  Appliance turned off

•  Power cord not plugged in.

•  No power at outlet.

•  Turn appliance on. See “Starting 

your appliance” on page 10.

•  Plug in power cord.

•  Check house circuit.