Whirlpool WMC10007A Guide D’Installation Rapide

1. Mark the four hole centers through the template onto the 

lower shelf of the cabinet.

2. Remove the template.
Following are the dimensions for the mounting holes on 
Template A:

 

3. Using 1/2" drill, drill four holes through the centers marked in 

Step 1.

4. Place the four C-washers near the holes inside the cabinet.

1. Remove the plugs from the four mounting holes on the top of 

the microwave oven. Save the plugs in case the microwave 
oven is used as a countertop unit in the future.

2. Start the four bolts into the mounting holes. Turn each bolt 

three or four times.

3. If the front edge of the cabinet is flush with the bottom of the 

cabinet (if there is no “lip” or trim overhang that extends below 
the cabinet bottom), proceed to Step 7.

4. If the front edge of the cabinet has a “lip” or trim overhang that 

extends below the bottom of the cabinet, measure the length 
of the overhang. Spacers may need to be used on the back 
bolts.

5. Determine the number of spacers needed for the back bolts. 

6. Place the appropriate number of spacers on the back bolts.

less than 1/2" (13 mm)
1/2"-3/4" (13-19 mm)
3/4"-1" (19-25 mm)

0, 1 or 2 spacers
2 or 3 spacers
3 or 4 spacers

A

A

B