Summit FF1119BIM Manuel Du Propriétaire

Page de 14
 
10 
 
Care and Maintenance 
 
Cleaning Your Refrigerator
1. 
Unplug the unit and remove the food, shelves and crisper. 
2. 
Wash the inside surfaces with a solution of warm water and baking soda. The 
solution should contain about 2 tablespoons of baking soda to a quart of 
water.  Rinse and dry thoroughly with a clean soft cloth. 
3. 
Wash the shelves and crisper with a mild detergent solution.  Rinse and dry. 
4. 
Wash the outside cabinet with warm water and mild liquid detergent. Rinse 
well and wipe dry with a clean soft cloth. 
5. 
Wring excess water out of the sponge or cloth before cleaning the area of the 
controls, or any electrical parts. 
CAUTION
 
: Failure to unplug the unit could result in electrical shock or personal 
injury.  Never use acids, chemical thinners, gasoline, benzene or hot water for 
cleaning any part of the refrigerator-freezer.  Also avoid any harsh cleansers 
or abrasive cloths or cleaning pads. 
Cleaning the Evaporation Tray
The evaporation tray is set at the back of the refrigerator-
freezer, just above the compressor.  Since dust and 
grime accumulating on this tray will decrease the 
evaporation efficiency, it should be cleaned every six 
months or so. 
To remove the evaporation tray, unscrew it and slide it 
out.  Clean it as you would any other plastic part.  Once 
the tray is clean, reposition it over the compressor, making sure that it is level 
and attached properly. 
 
Power Failure
Most power failures are corrected within a few hours and should not affect the 
temperature of your unit if you minimize the number of times the doors are 
opened.  If the power is going to be off for a longer period of time, you need to 
take the proper steps to protect your food. 
 
Vacation Time: 
Short vacations: Leave the appliance operating during vacations of less than 
three weeks. 
Long vacations: If the unit will not be used for several months, remove all food 
and unplug the power cord.  Clean and dry the interior thoroughly.  To prevent 
odor and mold growth, leave the doors open slightly, blocking them open if 
necessary.