Summit CT661BIDPL Manuel Du Propriétaire
4
Technical Information
Model Numbers
CT661BI (white)
CT663BBI (black exterior)
CT663BBI (black exterior)
Capacity
5.1 cu. ft.
Electrical Input
115V AC/60Hz
Rated Current
1.3A
Temperature of Freezer
5°F
Refrigerant
R134a, 2.3oz.
Installation
Built-in or free-standing
Ship Weight
102 lbs.
Unit Dimensions (W x D x H)
23.63" x 23.5" x 33.25"
NOTE: Specifications are subject to change without notice.
Installation Instructions
Before Using Your Appliance:
•
Remove the exterior and interior packing.
•
Before connecting the unit to a power source, let it stand for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
•
Remove the crisper, drip tray and shelves and clean them and the interior surfaces of
the unit with lukewarm water using a soft cloth.
the unit with lukewarm water using a soft cloth.
Installing the Refrigerator-Freezer:
•
Place the unit on a floor that is strong enough to support the appliance when it is fully
loaded. To level the unit, adjust the two leveling legs at the front.
loaded. To level the unit, adjust the two leveling legs at the front.
•
Models CT661BI and CT663BBI can be installed either free-standing, recessed or
built into an enclosure. When installing as a free-standing unit, allow at least 2”
(51mm) of space at the sides, top and rear of the unit to allow for proper air circulation
to cool the compressor and condenser. Even when built in, the unit requires at least
2” of clearance at the back, 1/8” (3mm) at both sides and 1/16” (1.6mm) at the top.
Take care that the air vents at the front of the appliance are never covered or blocked
in any way.
built into an enclosure. When installing as a free-standing unit, allow at least 2”
(51mm) of space at the sides, top and rear of the unit to allow for proper air circulation
to cool the compressor and condenser. Even when built in, the unit requires at least
2” of clearance at the back, 1/8” (3mm) at both sides and 1/16” (1.6mm) at the top.
Take care that the air vents at the front of the appliance are never covered or blocked
in any way.
•
This appliance is supplied with spacers that have to be
mounted onto the condenser tube to make sure there is
sufficient clearance between the appliance and the wall.
mounted onto the condenser tube to make sure there is
sufficient clearance between the appliance and the wall.