Summit FF63BDTPUBSSHHADA Manuel Du Propriétaire
10
Installation Instructions
Before Using Your Appliance
•
Remove the exterior and interior packing.
:
•
CAUTION:
After unpacking and before connecting to a power source, you MUST allow this
appliance to stand upright for at least 2 hours to allow the lubricant and refrigerant to
drain back into the compressor and stabilize. Failure to do so may adversely affect
performance and the lifetime of this unit.
After unpacking and before connecting to a power source, you MUST allow this
appliance to stand upright for at least 2 hours to allow the lubricant and refrigerant to
drain back into the compressor and stabilize. Failure to do so may adversely affect
performance and the lifetime of this unit.
•
Remove the shelves and clean them and the interior surfaces of the unit with
lukewarm water using a soft cloth.
lukewarm water using a soft cloth.
Installing the Pub Cellar
•
Place the unit on a floor or other surface that is strong enough to support the
appliance when it is fully loaded. To level the unit, adjust the two leveling legs at the
front.
appliance when it is fully loaded. To level the unit, adjust the two leveling legs at the
front.
:
•
Unless your particular model has the letters BI (built-in) in the model number, the
appliance is designed to be free-standing only and not recessed or built into an
enclosure. When installing, allow at least 4” (102mm) of space at the sides, top and
rear of the unit to allow for proper air circulation to cool the compressor and
condenser. Take care that any air vents at the front of the appliance are never
covered or blocked in any way.
appliance is designed to be free-standing only and not recessed or built into an
enclosure. When installing, allow at least 4” (102mm) of space at the sides, top and
rear of the unit to allow for proper air circulation to cool the compressor and
condenser. Take care that any air vents at the front of the appliance are never
covered or blocked in any way.
•
If your model has the letters BI in its model number, the appliance can be installed
either free-standing or built-in. If the unit will be built into an enclosure, you must still
allow at least 3/16” (5mm) of clear space on both sides and at the top, and 2” (51mm)
at the back. If the unit has an air vent at the front, take care that it is never covered or
blocked in any way.
either free-standing or built-in. If the unit will be built into an enclosure, you must still
allow at least 3/16” (5mm) of clear space on both sides and at the top, and 2” (51mm)
at the back. If the unit has an air vent at the front, take care that it is never covered or
blocked in any way.
•
The FF63BDTPUB models are supplied with spacers that must be mounted onto the
condenser tube at the back to make sure there is sufficient clearance between the
appliance and the wall. See illustration below.
condenser tube at the back to make sure there is sufficient clearance between the
appliance and the wall. See illustration below.
•
Locate your Pub Cellar away from direct sunlight and sources of heat (oven, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and can also reduce the
quality of items stored in models with glass doors. Heat sources may increase
electrical consumption. Extremely cold ambient temperatures may also affect the
unit's performance.
radiator, etc.). Direct sunlight may affect the acrylic coating and can also reduce the
quality of items stored in models with glass doors. Heat sources may increase
electrical consumption. Extremely cold ambient temperatures may also affect the
unit's performance.