Whirlpool CSP2861TQ Manuel De Montage

Use a UL listed power supply cord kit marked for use with 

clothes dryers. The kit should contain:

 

■

A UL listed 30-amp power supply cord, rated 120/240 volt 

minimum. The cord should be type SRD or SRDT and be at 

least 4 ft. (1.22 m) long. The wires that connect to the dryer 

must end in ring terminals or “U” shaped spade terminals 

with upturned ends.

 

■

A UL listed strain relief.

 Then choose a 4-wire power supply cord with ring 

or spade terminals and UL listed strain relief. The 

4-wire power supply cord, at least 4 ft. (1.22 m) 

long, must have four 10-gauge copper wires and 

match a 4-wire receptacle of NEMA Type 14-30R. 

The ground wire (ground conductor) may be either 

green or bare. The neutral conductor must be 

identified by a white cover.

 Then choose a 3-wire power supply cord with ring 

or spade terminals and UL listed strain relief. The 

3-wire power supply cord, at least 4 ft. (1.22 m) 

long, must have three 10-gauge copper wires and 

match a 3-wire receptacle of NEMA Type 10-30R.

If connecting by direct wire:
Power supply cable must match power supply (4-wire or 3-wire) 

and be:

 

■

Flexible armored cable or nonmetallic sheathed copper 

cable (with ground wire), covered with flexible metallic 

conduit. All current-carrying wires must be insulated.

 

■

10-gauge solid copper wire (do not use aluminum).

 

■

At least 5 ft. (1.52 m) long.