KitchenAid KFIS29BBMS-SS Manuel Du Propriétaire
TROUBLESHOOTING
29
3. Use a vacuum cleaner with a soft brush to clean the grille, the
open areas behind the grille and the front surface area of the
condenser.
condenser.
4. Replace the base grille when finished.
5. Plug in refrigerator or reconnect power.
Lights
The lights in both the refrigerator and freezer compartments are
LEDs which do not need to be replaced. If the lights do not
illuminate when the door or drawer is opened, call for assistance
or service. In the U.S.A., call 1-800-253-1301. In Canada call
1-800-807-6777.
LEDs which do not need to be replaced. If the lights do not
illuminate when the door or drawer is opened, call for assistance
or service. In the U.S.A., call 1-800-253-1301. In Canada call
1-800-807-6777.
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
In the U.S.A., www.kitchenaid.com In Canada, www.kitchenaid.ca
Operation
PROBLEM
POSSIBLE CAUSES
SOLUTIONS
The refrigerator will not
operate
operate
Check electrical supply
Plug the power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Make sure there is power to the outlet. Plug in a lamp to see
if the outlet is working.
if the outlet is working.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Check controls
Make sure the controls are turned on. See “Using the
Controls.”
Controls.”
New installation
Allow 24 hours following installation for the refrigerator to
cool completely.
cool completely.
NOTE: Adjusting the temperature controls to the coldest
setting will not cool either compartment more quickly.
setting will not cool either compartment more quickly.
Refrigerator Control is in Showroom
mode (on some models)
mode (on some models)
If the refrigerator is in Showroom mode, cooling is turned off
and “Showroom” will be illuminated on the control panel. See
“Using the Controls” for more information.
and “Showroom” will be illuminated on the control panel. See
“Using the Controls” for more information.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
fire, or electrical shock.
WARNING