Summit 50 lbs. Built-in Ice Maker - Integrated Frame Door Manuel D’Utilisation
28
Cubes are partially
formed or are white
on the bottom.
Not enough water in the
water trough.
Check if the water supply pressure is below
15 psig.
Check water supply or filter may be
restricted.
Check for a water leak at the water trough.
Noise during
operation
The feet are not leveled and
locked.
Level and lock the feet. See Leveling the Ice
Maker.
Certain sounds are normal.
See Normal Sounds.
The ice maker stops
suddenly while
making ice.
The electricity is off.
Reconnect the power supply line.
The room temperature is out
of the stated range.
Cut off the electricity and leave the ice
maker disconnected until the temperature
returns to within the stated range.
The ice storage bin is full of
ice.
Remove some ice cubes; make sure the
ice-full probe is free of ice.
The body of the ice
maker is electrified.
The ground line isn't in the
socket.
Use a socket meeting the grounding
requirements.
Scaling occurs
frequently inside
the machine.
The hardness level of the
water is too high.
Install a water-softening device in front of
the water inlet.
Water leaks from
the ice storage bin
The drainhole below the ice
storage bin is blocked.
Remove the ice storage bin and clean the
drainhole.
The drain hose is kinked or
improperly placed higher
than the floor of the ice
storage bin.
Check the drain hose to be sure water can
be drained out unhindered.
Buzzer alarm
Problem in pumping out
water
Check for correct operation of drain water
pump, water level switch and drain tube.