Vinotemp VT-SC-1 Manuel D’Utilisation
START-UP PROCEDURES
• Plug the cabinet into the electrical outlet; operate the cooler for at least
three hours. This will aid in refrigeration performance.
• Do not attempt to adjust the temperature control. The temperature
control is factory set to provide maximum performance.
LIGHT CONTROL
The inside light is controlled by the power. Plug in to turn on unit and light.
MAINTENANCE
Cleaning
• Before cleaning the appliance, always remember to unplug it.
• Before cleaning the appliance, always remember to unplug it.
• Unplug the cooler at the electrical outlet; never pull the service cord.
• Do not use sharp or pointed objects for cleaning.
• Clean the inside cabinet of the cooler with a clean damp cloth or with
neutral soap. Avoid damage by never using abrasive or flammable
cleaning products.
cleaning products.
• Clean the condenser at least once a month with a vacuum cleaner or a
brush to eliminate the dust accumulation.
Power failure
• Please minimize the frequency of opening the door during a power failure.
• Please minimize the frequency of opening the door during a power failure.
Most power failures are corrected within a few hours and the temperature
of your beverages will not be affected.
of your beverages will not be affected.
• If the power will be off for an extended period, proper procedure should
be followed for the stored cans.
Non-use for extended time frames:
• If your cooler is unused for extended periods, it is best to remove the
• If your cooler is unused for extended periods, it is best to remove the
cans, unplug and clean your cooler. Also please open the door to avoid
possible formation of condensation, mold or odors.
possible formation of condensation, mold or odors.
Moving the cooler
• Take out all the cans.
• Take out all the cans.
• Secure all loose parts inside the cooler.
• Tape the door shut.
• During transportation, make sure that the cooler is in the upright position.
Drip pan
• When the compressor stops working, water drops will drain through the
• When the compressor stops working, water drops will drain through the
outlet in the inner back wall into the drain pan (above the compressor).
• If the drain pan needs to be cleaned, pull the drain pan forward gently
and reinstall it after cleaning.
5
1 7 6 3 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m