Bunn Axiom Manuel D’Utilisation

Page de 17
Page 4
ADJUSTMENTS & PROGRAMMING
MAIN SCREEN
BREW LOCKOUT
 
This function allows the operator to prevent 
or allow brewing if the water temperature is less 
than the set READY temperature.
 
To access this function screen press and hold 
the right hidden switch. Release when the display 
reads: "BREW WIZARD" it will then read:
Press here 
for 
NO
Press here 
for 
DONE
Press here 
for 
YES
PROGRAM FUNCTIONS - BREW WIZARD
PROGRAMMING THE BREWER
 
The programming of the brewer is divided into two levels. Brewing adjustments are in "BrewWiz-
ard". Service functions are accessed in Level 2.
 
 The following function screens are in order of appearance. Each screen will have instructions on 
how to access, and the procedures to program the various functions of the brewer.
IMPORTANT PROGRAMMING NOTES
- READ CAREFULLY - 
 
To exit the programming mode at any time, press and release "ENABLE BREW ON/OFF" switch 
located on the front switch panel. The display will return to the MAIN SCREEN.
 
If none of the five programming switches are pressed within one minute during the setup of the 
brewer, the programming of the function screen that is being set will be exited and the display will 
return to the MAIN SCREEN.
 
Always remember to place an empty server and funnel under the sprayhead when operating the 
brewer during the set-up of PULSE BREW, CALIBRATE FLOW and testing the brew valve in SER-
VICE TOOLS/TEST OUTPUTS.
BREW  LOCKOUT?
 NO 
DONE 
YES
READY TO BREW
WATER TEMP: 200°
PROGRAMMING LOCKOUT SWITCH 
(Mounted on main control board)
This switch can be set to prevent access to the 
programming  settings  of  the  brewer.  Once  all 
the correct brew settings are programmed, the 
operator can set the switch to the "ON" position to 
prohibit anyone from changing the settings. With 
the switch in the "ON" position, the programming 
menus can still be accessed to view the current 
settings. However, no changes will be saved.
The YES or NO should be flashing. Select YES 
to prevent brewing if the water temperature is 
below the set READY temperature. Select NO 
to permit brewing at any water temperature.
When finished, press and release DONE. This 
will step to the next function screen. To return 
to the MAIN SCREEN at any time, press and 
release "ENABLE BREW ON/OFF".
Disconnect brewer from 
power  source  before 
removing any panel!
P3634
41154 041708