Intel C50277-001 Manuel D’Utilisation

Intel® Entry Server Chassis SC5275-E User Guide 

This chapter describes how to set the server up for the first time.  With the exception of replacing 
the front panel board (discussed in Chapter 4), it is necessary to remove only the left access cover, 
not the cover at the right.   

  Phillips (cross head) screwdriver (#2 bit) 
  Small flathead screwdriver 
  Antistatic wrist strap (recommended) 

Only technically qualified personnel should integrate this assembly. 

Follow these guidelines to meet and maintain safety and product regulatory requirements when 
integrating this chassis subassembly. 

Read and adhere to all of these instructions and the instructions supplied with this assembly.  If you 
do not follow these instructions, the UL listing will be void, and the product will most likely be 
non-compliant with other regional product laws and regulations. 

Before removing the access cover for any reason, observe these safety guidelines: 

  Turn off all peripheral devices connected to the server. 
  Turn off the server by pressing the power button on the front of the chassis.  Then unplug the 

AC power cord from the chassis or wall outlet. 

  Label and disconnect all peripheral cables and all telecommunication lines connected to I/O 

connectors or ports on the back of the chassis. 

  Provide some electrostatic discharge (ESD) protection by wearing an antistatic wrist strap 

attached to chassis ground—any unpainted metal surface—when handling components.