Netcomm NCT240 Manuel D’Utilisation

 

PWR indicator does 
not light up after 

Turning on the 
power. 

Power outlet, power cord, 
or internal power supply 

may be defective. 

• Check the power outlet by plugging in 

another device that is functioning 

properly. 

• Check the power cord with another 

device. 

SYS indicator does 
not light up after 

startup. 

Microprocessor, SDRAM, 
Flash or Software may be 

defective. 

• Verify that the switch are powered on. 
• Check the boot-up statement from 

console. The boot up procedure is Boot 
-> kernel->application 

•  

ADSL2+ LINK 
indicator does not 

light up after making 
a connection. 

NCT240 Switch, cabling, 
ADSL Line, or ADSL Switch 

Ports may be defective. 
 

• Verify that the Access Switch and 

attached CPE are powered on. 

• Be sure the RJ-21 cables are plugged 

into the Access Switch from ADSL2+ 

modem through the Phone-line 
punch-down block. 

• Verify that the cable length does not 

exceed specified limits. 

• Check the cable connections on the 

access Switch, punch-down block/patch 

panel, and the Extended Ethernet CPE 
for possible defects. Replace the 

defective cable if necessary. 

UP LINK indicator 
does not light up 

after making a 
connection. 

Network cable or Ethernet 
device attached to this 

port may be defective. 

• Verify that the access switch and 

attached device are powered on. 

• Be sure an Ethernet cable is plugged into 

both the switch and attached device. 

• Verify that the proper cable type is used 

and its length does not exceed specified 

limits. 

• Check the network cable connections 

for possible defects. Replace the 
defective cable if necessary.