SMC Networks SMC6752AL2 Manuel D’Utilisation
C
ONFIGURING
THE
S
WITCH
3-130
Configuring Global Settings
Global settings apply to the entire switch.
Command Usage
•
Spanning Tree Protocol
10
Uses RSTP for the internal state machine, but sends only 802.1D
BPDUs.
BPDUs.
•
Rapid Spanning Tree Protocol
RSTP supports connections to either STP or RSTP nodes by
monitoring the incoming protocol messages and dynamically adjusting
the type of protocol messages the RSTP node transmits, as described
below:
- STP Mode – If the switch receives an 802.1D BPDU (i.e., STP
monitoring the incoming protocol messages and dynamically adjusting
the type of protocol messages the RSTP node transmits, as described
below:
- STP Mode – If the switch receives an 802.1D BPDU (i.e., STP
BPDU) after a port’s migration delay timer expires, the switch
assumes it is connected to an 802.1D bridge and starts using only
802.1D BPDUs.
assumes it is connected to an 802.1D bridge and starts using only
802.1D BPDUs.
- RSTP Mode – If RSTP is using 802.1D BPDUs on a port and
receives an RSTP BPDU after the migration delay expires, RSTP
restarts the migration delay timer and begins using RSTP BPDUs on
that port.
restarts the migration delay timer and begins using RSTP BPDUs on
that port.
Command Attributes
Basic Configuration of Global Settings
•
•
Spanning Tree State – Enables/disables STA on this switch.
(Default: Enabled)
(Default: Enabled)
•
Spanning Tree Type – Specifies the type of spanning tree used on
this switch:
- STP: Spanning Tree Protocol (IEEE 802.1D); (i.e., when this option
this switch:
- STP: Spanning Tree Protocol (IEEE 802.1D); (i.e., when this option
is selected, the switch will use RSTP set to STP forced compatibility
mode).
mode).
- RSTP: Rapid Spanning Tree (IEEE 802.1w); RSTP is the default.
10. STP and RSTP BPDUs are transmitted as untagged frames, and will cross any VLAN boundaries.