SMC Networks SMC6752AL2 Manuel D’Utilisation
C
OMMAND
L
INE
I
NTERFACE
4-164
Link Aggregation Commands
Ports can be statically grouped into an aggregate link (i.e., trunk) to
increase the bandwidth of a network connection or to ensure fault
recovery. Or you can use the Link Aggregation Control Protocol (LACP)
to automatically negotiate a trunk link between this switch and another
network device. For static trunks, the switches have to comply with the
Cisco EtherChannel standard. For dynamic trunks, the switches have to
comply with LACP. This switch supports up to four trunks. For example, a
trunk consisting of two 1000 Mbps ports can support an aggregate
bandwidth of 4 Gbps when operating at full duplex.
increase the bandwidth of a network connection or to ensure fault
recovery. Or you can use the Link Aggregation Control Protocol (LACP)
to automatically negotiate a trunk link between this switch and another
network device. For static trunks, the switches have to comply with the
Cisco EtherChannel standard. For dynamic trunks, the switches have to
comply with LACP. This switch supports up to four trunks. For example, a
trunk consisting of two 1000 Mbps ports can support an aggregate
bandwidth of 4 Gbps when operating at full duplex.
Table 4-44 Link Aggregation Commands
Command
Function
Mode
Page
Manual Configuration Commands
interface
port-channel
interface
port-channel
Configures a trunk and enters
interface configuration mode
for the trunk
interface configuration mode
for the trunk
GC
channel-group
Adds a port to a trunk
IC (Ethernet)
Dynamic Configuration Command
lacp
lacp
Configures LACP for the
current interface
current interface
IC (Ethernet)
lacp system-priority Configures a port's LACP
system priority
IC (Ethernet)
lacp admin-key
Configures a port's
administration key
administration key
IC (Ethernet)
lacp admin-key
Configures an port channel’s
administration key
administration key
IC (Port Channel) 4-171
lacp port-priority
Configures a port's LACP port
priority
priority
IC (Ethernet)
Trunk Status Display Command
show interfaces
status port-channel
show interfaces
status port-channel
Shows trunk information
NE, PE
show lacp
Shows LACP information
PE