Axis Communications 241S Manuel D’Utilisation

This section describes how to configure the AXIS 241Q/241S for alarm handling. Various 

actions can be configured to run when certain types of events occur.

A set of parameters describing how and when the video server is to perform certain actions
- the circumstances that start an event

e.g. at a signal from an external device, such as a door 
switch or a motion sensor

- the circumstances that start an event

e.g. at a pre-programmed time

- what occurs when the event runs

e.g. video images uploaded to an FTP server, email notifi-
cation sent, etc.

Event Servers are used for e.g. receiving uploaded image files and/or notification 

messages. To set up Event server for your AXIS 241Q/241S, go to Setup > Event 

Configuration > Event Servers and enter the required information according to the 

selected server type.

For details on each setting, please refer to the online help

available from each web 

page.

Pre-trigger and Post-trigger buffers will be lost if the connection to the event server fails.

When the setup is complete, the connection can be tested by clicking the Test button (the 

connection test takes approximately 10 seconds). 

Event type
Triggered Event (see page 
33)
Scheduled Event (see page 
34)
Action