Sony EBS-SP10 Manuel D’Utilisation

SP-TUNE User Manual 

 

15

If the password is reset, the user is prompted to enter new password on his/her first access to V-Chip 

limit. For all subsequent accesses the user will have to use the password that was specified during the first 
access.  In the event the password is forgotten the V-Chip settings can reset by holding the enter button 
for  5 sec.  When prompted for the password enter right, left, right, left, enter and it will be reset to default 
values. 

 
 

 
 

 
 
 

 
 

 
 

 
 
 

 
 

 

Key on remote is pressed but 

nothing happens 

See if the upper LED of SP-TUNE is fast-blinking while 

pressing key and aiming remote at IR sensor on Plasma 
Display. If it is not -– check the batteries in the remote. If the 

batteries are good – check the cable connections between 

the Plasma Display and the SP-TUNE. 

 

The Plasma Display does not 

turn on when the SP-TUNE is 

turned on. 

Check Plasma Display power. Check SP-TUNE power (if 

the LEDs blink). Check SP-TUNE-plasma display 

connection cable.  

No control of Plasma via RS-

232 connection to Sp-Tune 

Check cable connection.  If connection is ok, check model 

number of plasma as some models require a null cable.  
Under panel settings check to see if correct model is 

selected. 

Cannot switch to a particular TV 

channel using channel +/- 

browse keys. 

The channel is selectable by browsing keys only if it is 

marked as “valid”. To be marked as “valid” the channel must 

have a good TV signal during the “channel scan” operation. 

Repeat the channel scan (making sure aerial/cable 
connection is good). Also the channel validity can be edited 

manually.