Sony EBS-SP10 Manuel D’Utilisation

SP-TUNE User Manual 

 

8

 
The respective audio input channels are selected when the corresponding video input is selected 

(e.g., S-Video input). 

 
Component RGB+HV or YPbPr video signal can be connected to the 15-pin male connector of SP-

TUNE: 

-  using the standard VGA cable for RGB+HV VGA signal; 
-  using the supplied adapter cable for YPbPr signal (Y=Green RCA, Pb=Blue RCA, Pr=Red RCA). 

 
Different views of the SP-TUNE: 

 

  

 

The coaxial connector (ANT) of SP-TUNE is RF signal input – either aerial or cable TV, UHF/VHF, 

if the SP-TUNE shall be used as TV tuner. 

 

RJ11 connector of SP-TUNE is used as a service port for Sony.  Nothing should be connected to this 

port.  

 

 Damage may occur if plug into a different port such as a phone line.  This will void the 

warranty. 

 

Connect the supplied 12v DC adapter to the power jack of the SP-TUNE unit. 
Note that depending on pre-programmed settings the SP-TUNE can switch on automatically upon 

attaching power supply, or remain in a “sleep” state. 

 
It is recommended to connect the power supply only after all other connections are done. 

 

The SP-TUNE has many advanced features to enhance the typical viewing and usability of a TV 
Tuner.  

 

A user can switch the unit on or off, control volume level, switch the current TV channel, either 

directly entering channel number, or browsing through valid channels using Channel +/- keys (usually 
Arrow Up/Down key on a remote controller). “Valid” channels are the channels where a valid TV signal 
was discovered during recent “channel scan” operation (in stand-alone mode).  

Since the SP-TUNE allows to attach several additional video signal sources to its AV inputs, to 

facilitate user selection of these inputs SP-TUNE maps some additional “channel numbers” to its AV 
inputs. So when a user selects one of these “channels”, the SP-TUNE switches to the respective AV input.