Honeywell IV REV B Manuel D’Utilisation
Pan / Tilt / Zoom
________________________________________________________________________________________________________
100
100
Advanced PTZ Setup
Note
Preset and Tour options may vary depending on the camera
Creating and Viewing Preset Positions
A Preset Position is a user-defined location where the camera can be pointed, zoomed
in, and focused. Preset positions can be defined and labeled if the camera supports
this.
in, and focused. Preset positions can be defined and labeled if the camera supports
this.
Creating a Preset
1. Inside Setup, click the PTZ tab and select a camera from the Channel list.
2. Select the Pan/Tilt Connection check box and select the appropriate PTZ protocol.
3. Under PTZ Status on Close, click Controller to open the PTZ graphical gontroller.
4. In the Preset box, select a Preset from the list to modify (a red box will appear
2. Select the Pan/Tilt Connection check box and select the appropriate PTZ protocol.
3. Under PTZ Status on Close, click Controller to open the PTZ graphical gontroller.
4. In the Preset box, select a Preset from the list to modify (a red box will appear
around the Preset).
5. Use the controls on the Graphical Controller to move the selected camera to the
desired position.