Honeywell IV REV B Manuel D’Utilisation
Setup Options
________________________________________________________________________________________________________
52
52
Video Loss Alarm
The DVR supports a Video Loss Alarm function which allows an Alarm Event to occur
when a camera loses its signal. The lost signal can be due to camera power failure to
the camera, the camera cable being cut or unplugged, or the camera being damaged in
some way.
In order to use Video Signal Loss detection, cameras must either be Enabled or
Disabled. This is because the DVR needs to know which cameras it should expect to
the camera, the camera cable being cut or unplugged, or the camera being damaged in
some way.
In order to use Video Signal Loss detection, cameras must either be Enabled or
Disabled. This is because the DVR needs to know which cameras it should expect to
receive signals from. To enable camera(s), open Frame Setup, and set the Images Per
Second to anything above zero. By designating zero images per second the camera will
not be used by the DVR.
Second to anything above zero. By designating zero images per second the camera will
not be used by the DVR.
Activate Audio Alarm (BEEP)
When video loss occurs, an internal speaker on the DVR will sound an alarm.
Video Loss Alarm Log
When video loss occurs, the event is recorded in the DVR log.
Activate Alarm Output
When video loss occurs, an alarm (control) output is activated.
Activate Alarm Output
When video loss occurs, an alarm (control) output is activated.
Volume
The volume control allows fine tuning of the volume settings on the recorder.
Volume Options:
Volume Options:
• Speakers – Used to
adjust the volume for all
sound coming from the
system’s speakers
sound coming from the
system’s speakers
• System Sounds – Used
to adjust the volume for
the system sounds
the system sounds
exclusively.