Honeywell HSVR-04 Manuel D’Utilisation

Honeywell

Motion Detection

The detection menu is shown as below. See

 Event type: From the drop-down list you can select the “Motion

Detection” type.

 Channel: Select the video channel for the motion detection setting.
 Record Channel: Select the channel to activate the recording function

once the alarm has sounded. Please make sure you have set the MD
recording in the schedule interface (Main MenuSettingSchedule)
and automatic recording in manual record interface (Main Menu-
>Advanced->Manual Record)

 Delay: When detected motion is completed, the system will continue

alarm output and recording for a specified time respectively. The value
ranges from 10-300(Unit: second).

 Region:

Click

Select, the interface is shown as in

Figure 4-14

. Here

you can set the motion detection zone. There are 396(PAL)/330(NTSC)
small zones.

 Sensitivity: The system supports 6 levels. The sixth level has the

highest sensitivity. The fifth or lower levels are recommended to avoid
setting a false alarm.

 Show message: The system will send message to the local host screen

to alarm you if you have enabled this function.

 Send email: The system can send out an email to alert you when the

alarm occurs.

 PTZ activation: Here you can set PTZ movement (of any video

channels) such as going to a preset when motion is detected in the
current video channel. Click Select, and you can see an interface is
shown as in

Figure 4-15

 Period:

Click

Set to determine the period for the channel to be armed

for motion detection. See the interface shown as in

Figure 4-16

. Here

you can set for business days and non-business days. In

Figure 4-16

click Set, and you will see an interface as shown in

Figure 4-17

. Here