Maxon Telecom SP-200K Series Manuel D’Utilisation

Flashing green LED indicates call received, and if programmed, an alert tone

is generated. Conversation can then begin by pressing the P-T-T button. LED

will continue to flash until call has been answered.

Your radio has the ability to lock the channel I or J buttons and scan

button to prevent accidental button presses. To lock these buttons, press

and hold the scan button (first button below the P-T-T bar) for approximately

4 seconds. The display will show "LO" and two confirmation beeps will

sound. To unlock the keypad, press and hold the scan button again for

approximately 4 seconds.

The P-T-T and monitor buttons can be locked by pressing the * and #

keys at the same time for approximately 1 second. Repeat the procedure

to unlock these buttons.

Your SP-200K Series radio has a sophisticated microprocessor control which

provides a series of audible alert tones. Upon each power-up, a quick melody

*

indicates that the self-test of the microprocessor functions has been completed.

A series of tones may be sounded with any of the following conditions:

Attempt to transmit on a channel set for receive only

Attempt to transmit on a channel that is already in use when busy channel

lockout has been programmed into the radio*

Transmitting time has exceeded time-out timer programmed length*

Low battery condition

Selecting a channel with no programmed frequency

P-T-T lockout

TX Time-out-timer

Toggling scrambler on and off

Toggling keypad on and off

Keypad alerts

Side button alerts

Decode of valid Selcall address

Auto-mute alert

* Indicates a function that is initially programmed into the radio by your Dealer.

See the Status Indicators and Audible Alert Tones chart on next page for details.

9