Manuel D’UtilisationTable des matièresfront cover1before you start2tools and materials needed for installation2electrical requirements2power supply cord2electrical connection3exhaust requirements4now start51 - put on safety glasses and gloves52 - remove shipping cardboard base53 - remove parts from plastic package54 - insert the rear leveling legs into the holes in the rear corners55 - push up on one leg to see that the other leg goes down56 - find diamond marking on front legs and insert into front corners57 - stand the unit upright onto a piece of cardboard or hardboard58 - cut the carton down one corner and remove carton59 - remove the rear corner posts and lower front corner posts610 - move foam shipping pieces enough to clear the washer lid611 - read the yellow card and then remove the shipping strap612 - remove the yellow card and hoses from the basket613 - release washer lid by pushing up on latch and close lid614 - disconnect power supply and connect cord to the dryer615 - insert a flat washer into each end of the inlet hoses616 - attach hose to bottom inlet valve first, then second hose to the top617 - follow the instructions carefully to install the drain hose618 - install the drain hose to your drain system619 - move washer/dryer close to final position620 - check for proper length of drain hose621 - run water through both faucets before attaching hoses622 - attach bottom inlet hose to hot water faucet, top to cold623 - tilt unit forward to adjust the self-leveling legs724 - wrap the beaded strap around the drain hose and standpipe or tub725 - remove the access panel above the washer726 - determine the length of exhaust duct that is needed727 - connect exhaust duct to dryer and then to the hood728 - check electrical requirements729 - check that all parts are now installed730 - check that you removed all the shipping pieces731 - check that you have all of your tools732 - turn on water faucets and check for leaks733 - replace the access panel734 - read the Use and Care Guide carefully735 - plug power supply cord into grounded outlet and start washer736 - start dryer and let it complete a full heat cycle7recessed and closet installation instructions8product dimensions8if washer/dryer does not operate9when moving the washer/dryer9if you need assistance9Taille: 1,4 MoPages: 9Language: EnglishOuvrir le manuel