Agilent Technologies N3280A Manuale Utente

6 – Language Dictionary

SCPI Programming Commands - At a Glance

Table 6-1. Subsystem Commands Syntax

ABORt

Resets the trigger system to the Idle state

CALibrate
:CURRent
[:LEVEL] (@channel)

Calibrate output current and low current measurement range

:LIMit
[:POSitive] (@channel)

Calibrate positive current limit

:NEGative (@channel)

Calibrate negative current limit

:MEASure <max_val>, (@channel)

Calibrate high and medium current measurement range

:DATA <n>

Enters the calibration value

:DATE <date>

Sets the calibration date

:LEVel <level>

Advance to next calibration step (P1 | P2)

:PASSword <n>

Set numeric calibration password

:SAVE

Save new cal constants in non-volatile memory

:STATE <bool> [,<n>]

Enable or disable calibration mode

:VOLTage (@channel)

Calibrate output voltage and voltage measurement range

INITiate
[:IMMediate]
:NAME <name>

Enable the named trigger system (TRANsient | ACQuire)

FETCh
:ARRay
:CURRent [:DC]? (@list)

Returns the digitized instantaneous current

:VOLTage [:DC]? (@list)

Returns the digitized instantaneous voltage

[:SCALar]
:CURRent [:DC]? (@list)

Returns output current dc measurement

:VOLTage [:DC]? (@list)

Returns output voltage dc measurement

MEASure
:ARRay
:CURRent [:DC]? [max_val,] (@list)

Digitizes and returns the instantaneous output current

:VOLTage [:DC]? (@list)

Digitizes and returns the instantaneous output voltage

[:SCALar]
:CURRent [:DC]? [max_val,] (@list)

Digitizes and returns average (dc) output current

:VOLTage [:DC]? (@list)

Digitizes and returns average (dc) output voltage

OUTPut
[:STATe] <bool>, (@list)

Enables/disables the selected dc source output

:OSCProtect
[:STATe] <bool>, (@list)

Enables/disables oscillation protection on the selected output

:PROTection
:CLEar (@list)

Reset latched protection

SENSe
:CURRent[:DC]
:RANGe [:UPPer] <max_val>, (@list)

Selects the current measurement range

:FUNCtion <function>, (@list)

Configures the measurement sensor (

"VOLTage" | "CURRent"

)

:SWEep
:NPLCycles <n>

Sets the number of ac power line cycles

:OFFSet
:POINts <n>

Defines the trigger offset in the measurement sweep

:POINts <n>

Defines the number of data points in the measurement

:TINTerval <n>

Sets the measurement sample interval

:WINDow [:TYPE] <type>

Sets measurement window function

(HANNing | RECTangular)