Agilent Technologies 8935 series e6380a Manuale Utente

C:\Spk\Ref\RefGuideRevE\CdmascrnE2.fm

CDMA Measurements - Screens and Control Fields

Adjacent channel power can be measured at frequency offsets of 0 to 
3 MHz, and filter bandwidths of 10 kHz to 1.23 MHz with 100 Hz 
resolution. This measurement returns three, channel-tuned power 
values:

•

 - the channel power at the center frequency

•

 - the ratio of the total power in the specified 

bandwidth at the specified offset above the center frequency, to the 
power at the center frequency.

•

 - the ratio of the total power in the specified 

bandwidth at the specified offset below the center frequency, to the 
power at the center frequency.

This measurement must be calibrated using the 

 field each 

time the tune frequency is changed. You must always remove power at 
the ANT IN or RF IN/OUT connector before calibrating channel power 
to ensure accurate calibration.

Screens on which this measurement is made:   

• CDMA ANALYZER

• CDMA GENERATOR

Channel power can be measured using one of two filters selected with 
the 

 field on the CDMA ANALYZER screen:

•

 - Channel power is the absolute power level of the RF signal 

in a 1.2 3MHz bandwidth centered around the RF channel or tune 
frequency setting. 

•

 - Channel Power measures the power in a 30 kHz band. 

This measurement must be calibrated using the 

 field 

each time the tune frequency is changed. You must always remove 
power at the ANT IN or RF IN/OUT connector before calibrating 
channel power to ensure accurate calibration.

Refer to the Agilent Technologies 8935 CDMA Base Station Tests 
Applications Guide for more information about channel power 
measurements.