Agilent Technologies 8935 series e6380a Manuale Utente
56
Chapter 3
C:\Spk\Ref\RefGuideRevE\Opoverv.fm
Operating Overview
Displaying Analog Measurements
Displaying Analog Measurements
RF Measurements
Frequency Error, Frequency
RF Frequency Error and RF Frequency are displayed on the RF
ANALYZER, RF GENERATOR, and AF ANALYZER screens.
ANALYZER, RF GENERATOR, and AF ANALYZER screens.
Figure 3-5
Displaying RF Frequency Error or RF Frequency, and TX
Power
Power
Transmitter (TX)Power
TX Power
is only measured and displayed here when the
Input Port
on the RF ANALYZER screen is set to
RF In
. If
Ant
(antenna) is
selected, the measurement is replaced by four dashes (- - - -).
You can measure low power levels on the ANT IN port using the
spectrum analyzer.
spectrum analyzer.
for more information on measuring transmitter power.
CAUTION
Connecting a signal of >60 mW to the ANT IN (antenna) port can cause
instrument damage (although internal protection circuits can typically
withstand a short-duration signal of 1 or 2 Watts). If the overpower
circuit is triggered, remove power from the ANT IN port and turn the
Test Set off and on to reset it.
instrument damage (although internal protection circuits can typically
withstand a short-duration signal of 1 or 2 Watts). If the overpower
circuit is triggered, remove power from the ANT IN port and turn the
Test Set off and on to reset it.
Choices:
Freq Error
Frequency
Frequency
TX
Power
Power