Soundstream Technologies 1002 Manuale Utente

Your 

 amplifier is protected against both overheating and short circuits

by means of main power fuses and the following circuits:

Auto High Current power supply

 

Protection

Soundstream 

 amplifier is protected by a limited warranty.

Please read the enclosed 

warranty card 

for details.

Ground Fault Differential

Smart Power Supply Thermal Rollback   a Thermal Protection Circuit

POWER 

1. No power or ground at the amp.

No Sound and power LED is not lit

2. No remote turn-on signal
3. Blown fuse near the battery

1. No signal input

No sound, power LED is lit.

2. The 

 switch

is in the 

 position. Move it to the

“OUT” position.

Repeatedly blow amp fuse;

frequent activation of Smart Power

1. Speaker or leads may be shorted

Supply Circuit

2. Verify adequate amp ventilation

Not enough input sensitivity while

Be sure both Left and Right input

using the Balanced Input

signal switches are set to the 
position.

Very little output, or output is
muffled.

Make sure that 

 the L.P. and

the H.P. 

 aren’t

engaged

Left and Right “Clip” indicators
lighting

Output signal level is too high and
the amplifier output is clipping.
Reduce the level either at the 

source

or at the input level controls.

1. Make sure the Right Input Signal

Switch is in the 

 position.

Alternator whine while using
Unbalanced RCA inputs

2.

Try the Left Input Signal switch

in the “BAL” and “UNBAL” position:
leave the switch in the quietest
setting. This will not effect the
performance of the amplifier.

THD

 

20 Hz to 

   0.5 

 

300 

 to 5.0 Volts

 Ohms

Low 

Hz   220 Hz at 24 

Hz   160 Hz at 12 dB/Octave

boost, High Pass filter from 

to 

Hz.

0 to   

 Boost; Boost and Sub Sonic filter,

variable from 30 to 70 Hz.

RUB
RUB
RUB

CON502: 11   X 9.8” X 2.25”
CON702: