Toshiba IK-52N Manuale Utente
4
Rear Side
1
O
N
2
3
4
5
6
7
8
9
0
3
4
5
6
7
8
9
0
ON
OFF
EXT
INT
HD/VD
75
Ω
SHT
TRG
M.G
MIN
MAX
M GAIN
VIDEO OUT
DC IN/SYNC
DC IN/SYNC
FRM
4
1
2
3
4
5
1
2
3
4
5
Enlarged
1
VIDEO OUT DC IN/SYNC plug (12-pin connector)
This receives +12 VDC, and sends a video signal from the camera. When a synchronizing signal
generator is connected to this plug and an external synchronizing signal (HD/VD signal) is applied,
the camera can be operated synchronously with the external signal.
This receives +12 VDC, and sends a video signal from the camera. When a synchronizing signal
generator is connected to this plug and an external synchronizing signal (HD/VD signal) is applied,
the camera can be operated synchronously with the external signal.
2
75
Ω
terminal switch (Terminal of external synchronizing HD/VD input signal)
Set this switch to OFF when not terminated. The factory setting is ON.
3
HD/VD signal input/output selector switch
Set to INT to output the HD/VD signals from the camera, and EXT to input external HD/VD signals.
The factory setting is EXT.
Set to INT to output the HD/VD signals from the camera, and EXT to input external HD/VD signals.
The factory setting is EXT.
4
MODE SELECT switch
1
Shutter speed setting (MODE SELECT switch bit 1 to 4)
Set to the shutter speed suitable for the shooting conditions. For each setting position, refer to
P. 7. The factory setting position is shutter OFF.
Set to the shutter speed suitable for the shooting conditions. For each setting position, refer to
P. 7. The factory setting position is shutter OFF.
2
Reset restart/External trigger mode setting (MODE SELECT switch bit 5 to 7)
For each setting position, refer to P. 8 to 13. The factory setting position is NORMAL.
For each setting position, refer to P. 8 to 13. The factory setting position is NORMAL.
3
Trigger polarity setting (MODE SELECT switch bit 8)
Selects the polarity of an externally inputted trigger.
Selects the polarity of an externally inputted trigger.
OFF: Positive ON: Negative
The factory setting position is OFF.
4
Field accumulation/Frame accumulation setting (MODE SELECT switch bit 9)
For the mode setting, refer to P. 6. The factory setting position is Field accumulation.
For the mode setting, refer to P. 6. The factory setting position is Field accumulation.
5
Gain selector switch setting (MODE SELECT switch bit 0)
This switch selects the modes OFF (fixed) or ON (manual). The factory setting is OFF (fixed).
This switch selects the modes OFF (fixed) or ON (manual). The factory setting is OFF (fixed).
5
Manual gain (M GAIN) control knob
This adjusts the gain of a video signal when the gain mode is set to ON by the MODE SELECT
switch bit 0 on step
This adjusts the gain of a video signal when the gain mode is set to ON by the MODE SELECT
switch bit 0 on step
5
. The factory setting is the fully counterclockwise position.