Hitachi VM-E220A Manuale Utente
General Maintenance
- 42 -
Cleaning the Lens and Picture Tube of the Electronic Viewfinder
The lens of the electronic viewfinder can be user-cleaned if dust, dirt, or other foreign matter adheres to it.
1. Rotate and remove eye cup.
2. Clean the picture tube face and lens.
To prevent scratching, use a soft non abrasive cloth, swab or lens cleaning paper.
3. Fit the projection of the eye cup into the groove in the viewfinder and rotate the eye cup in the direction of the
arrow.
2. Clean the picture tube face and lens.
To prevent scratching, use a soft non abrasive cloth, swab or lens cleaning paper.
3. Fit the projection of the eye cup into the groove in the viewfinder and rotate the eye cup in the direction of the
arrow.
Periodic Maintenance
A precision electromechanical device, the Hitachi VM-E220A requires maintenance after a period of normal use.
We expect that no other maintenance other than head cleaning will be required during the period of warranty
unless the camcorder is used either heavily or seldom. Defective parts are covered by the warranty. Normal
maintenance is the responsibility of the owner. Consult your dealer or local VCR service center for
recommendations regarding normal maintenance based on your use patterns, location, and the age of the
camcorder.
We expect that no other maintenance other than head cleaning will be required during the period of warranty
unless the camcorder is used either heavily or seldom. Defective parts are covered by the warranty. Normal
maintenance is the responsibility of the owner. Consult your dealer or local VCR service center for
recommendations regarding normal maintenance based on your use patterns, location, and the age of the
camcorder.
Troubleshooting
Quality is very important at Hitachi. We inspect and check every camcorder carefully at the factory under the most
rigid quality control and inspection systems. If problems develop please check the following possible solutions
before inquiring about professional service.
rigid quality control and inspection systems. If problems develop please check the following possible solutions
before inquiring about professional service.
INSERTING OR REMOVING THE CASSETTE
Symptom
Check Point & Correction
Cassette holder cannot be opened
when you slide EJECT switch
when you slide EJECT switch
Connect the power source
Cassette cannot be inserted into
cassette compartment
cassette compartment
Load cassette in direction indicated by
arrow on cassette. Cassette window
must be toward outside.
arrow on cassette. Cassette window
must be toward outside.
CAMERA RECORDING
Symptom
Check Point & Correction