Lexicon BD-30 Manuale Utente
Lexicon
74
References
Useful Notes
• In order to prolong the service life of your player, it is recommended to wait at least 30 seconds before you turn it on again after
switching it off.
• Remove disc and turn power off after operation.
• Some functions of the player may not be applicable to certain discs.
• Some discs with special features may not be fully supported by the player. This is not a malfunction of the unit.
• In case of player malfunction, please turn it off, wait for 30 seconds and turn it back on. If the problem still exists, please follow the
• Some functions of the player may not be applicable to certain discs.
• Some discs with special features may not be fully supported by the player. This is not a malfunction of the unit.
• In case of player malfunction, please turn it off, wait for 30 seconds and turn it back on. If the problem still exists, please follow the
troubleshooting instructions or contact a Lexicon service center.
Troubleshooting
Use this chart to resolve general operational problems. If there are any problems that you cannot resolve, please contact your Lexicon
service center.
Symptom
Possible Cause
Solution
Reference
Page
No sound
Audio cable is not properly connected
Check audio cable, and then reconnect if necessary.
13 - 19
Mute is activated
Press the MUTE button to cancel the mute.
30
Volume is too low
Press the VOL + button to increase the volume to 100.
30
SACD is played and the audio connection is coaxial or optical
digital audio
This is not supported due to copyright restrictions of SACD.
Please use the analog or HDMI audio output. Alternatively, you
may set SACD Priority to CD mode and the player will play the CD
layer.
18, 53
DVD-Audio is played and the audio connection is coaxial or
optical digital audio
This is not supported due to copyright restrictions of SACD.
Please use the analog or HDMI audio output. Alternatively, you
may switch to the DVD-Video playback mode.
18, 53
No picture
Video cable is not properly connected
Check video cable; reconnect if necessary.
13 - 14
TV input is not correctly selected
Select the input to which the player is connected.
“Pure” mode engaged
Check the “PURE” display on the front panel, and press the PURE
button to cancel this mode.
44
Video output format is not support by the TV
Select a proper output resolution that is supported by your TV.
35
Video system is not supported by the TV
When playback is completely stopped, press the P/N button or set
the correct TV System in the Setup Menu.
35, 54