Vermont Casting SDDVREB Manuale Utente

28

 

 

18 

40 feet

 

20 

25 feet

 

22 

16 feet

Use only a thermostat rated for 500 - 750 millivolts.
Check the table below for the appropriate gauge 
thermostat wire to use for the length of lead required in 
your installation.

1.  Install the wall thermostat in the desired location and 

run the wires to the stove location. Terminate these 
leads with 1/4” female connectors.

2.  Connect the thermostat wires to the valve.  (Fig. 49)
This completes assembly of the Stardance Rear 
Vent stove.

Grasp the Front Plate and lift it into position, engaging 
the two steel tabs at the upper corners behind the adja-
cent bosses in the Side Plates. (Fig. 50) Seat the Front 
against the Sides so that the tabs at the bottom lip 
engage with the notches in the edge of the stove base.
When properly installed, the bottom of the Front Plate 
cannot be pulled away from the sides without also lifting 
it up.
If you are installing optional Warming Shelves, do so 
now, according to the instructions supplied with that kit.

ST228

attach switch

wires to valve

12/99

PILO

T

ADJ

TP

TH

TPTH

ST228

Fig. 49  Attach switch wires to valve.

ST940

Stardance

Remove Front

6/07

Fig. 50   Install Stove Front.

ST940

Bottom Tabs 

Engage Notch in 

Base