Monte Carlo Fan Company 5CMR56 Manuale Utente

Install up light reflector to fan body.

Align hole in downrod with hole in

yoke and install cross pin.  

Install cotter pin into cross pin.

Take out pin and keeper clip and

then loosen the 2 set screws on the

yoke to let the downrod slip into

yoke.

Thead leadwires and safety cable

through the downrod.

Tighten the 2 set screws on the yoke

once the downrod is in place. Then

tighten locking nut.

For Canadian installation in both flush and downrod

mode the safety cable must be installed into the

house structure beams using the 3” lag screws pro-

vided.  Make sure that when the safety cable is

fully extended the leadwires are longer than the

cable and no stress is placed on the leadwires.

Safety Cable

Lag Screw

Install 4 Max. 15 watt bulbs into the

sockets on top of the fan as shown.

Install 4 screws to hold glass to fan

housing. Do not overtighten as this

could crack the glass.

Hang assembled fan from the mounting brack-

et. Make sure the fan is hanging straight.

Rotate fan until the tab on the Mounting brack-

et engages the slot on the Downrod Ball.  This

must be done to prevent the fan body from

rotating when the blades are in motion.

Rotating the ball will also close mount ring.

Install 4 screws to hold reflector in

place.

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wirenut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.