Hunter Fan 9103x Manuale Utente

44801-01 

02/07/2008

44801-01 

02/07/2008

This appliance is for household use 

only and may be plugged into any 

120-volt AC electrical outlet (ordi-

nary household current). DO NOT 

use any other type of outlet.

 

 

This unit is suitable for grounded 

receptacle use only.

The cord has a grounded plug as 

shown in Figure 1. An adapter, as 

shown in Figure 2, is available for 

connecting three-blade grounding-

type plugs to two-slot receptacles. 

The green grounding lug extending 

from the adapter must be con-

nected to a permanent ground such 

as a property grounded outlet box. 

The adapter should not be used if 

a three-slot grounded receptacle is 

available.

Grounded Outlet

Box Cover

Metal

Screw

Adapter

Grounding

Means

LINE CORD SAFETY TIPS
  1.  NEVER pull or yank on the 

cord or the appliance.

  2.  To insert plug, grasp it firmly 

and guide it into the outlet.

  3.  To disconnect the appliance, 

grasp the plug and remove it 

from the outlet.

  4.  Before each use, inspect the 

line cord for cuts and/or abra-

sion marks. If any are found, 

the appliance should be 

serviced and the line cord re-

placed. Please return it to our 

Service Department or to an 

authorized service representa-

tive.

  5.  NEVER wrap the cord tightly 

around the appliance, as this 

could place undue stress on 

the cord where it enters the 

appliance and could cause it to 

fray and break.

  6.  DO NOT operate appliance if 

the line cord shows any dam-

age, if the appliance works 

intermittently or stops working 

entirely.

This appliance is for household 

use only.
  1.  Place the fan on a dry, safe, 

flat surface where it cannot fall 

or be pulled by the cord.

  2.  Plug the fan into a grounded 

120-volt AC electrical outlet 

(ordinary household current).  

DO NOT use any other type 

of outlet. Make sure that the 

rated voltage of the fan is the 

same as the power source be-

fore plugging it into the power 

source.

  3.  Turn the fan “ON” or “OFF” by 

turning the Power/Speed Con-

trol knob. The power should 

always be OFF before unplug-

ging the fan.

  4.  To select the speed, turn the 

Power/Speed Control knob 

from OFF to the desired speed 

setting: O (off), I (low), II (me-

dium), III (High).

  5.  To control the upward and 

downward direction of airflow, 

loosen the screw on the side of 

the fan housing neck. Adjust to 

the desired angle and tighten 

the screw.

  6.  To make the fan oscillate, push 

the oscillation knob down. To 

stop oscillating, pull the oscil-

lation knob up. The oscillation 

knob is located on the top of 

the fan housing, near the han-

dle.

Handle

Oscillation Knob

Power/Speed 

Control Knob

Motor Housing

Up/Down Adjustment Screw

Base

Decorative Pieces

(Only on 9103X & 

9703x models)

Grounded

Plug

Grounding Pin

Grounded Outlet

Box Cover