Heat Controller BG-123A Manuale Utente

—7—

1. Remove the fan. (Refer to section 2.2.2)
2. Remove the shroud. (See Fig. 9)
3. Re-install the components by referring to the

removal procedures, above.

1. Remove the cabinet. (Refer to section 2.1.2)
2. Remove the clamp cord and disconnect the wire

housing in control box. (Refer to section 2.1.3)

3. Remove the turbo fan. (Refer to section 2.2.2)
4. Remove the fan. (Refer to section 2.2.2)
5. Remove the 4 or 2 screws which fasten the motor.

(See Fig. 10)

6. Remove the motor.
7. Re-install the components by referring to the

removal procedures, above.

1. Remove the cabinet. (Refer to section 2.1.2)
2. Discharge the refrigerant system using a Freon

TM

Recovery System.
If there is no valve to attach the recovery system
to, install one (such as a WATCO A-1) before
venting the Freon

TM 

. Leave the valve in place after 

servicing the system.

3. Disconnect the 3 leads from the compressor.
4. After purging the unit completely, unbraze the

suction and discharge tubes at the compressor
connections.

5. Remove the 3 nuts and the 3 washers which

fasten the compressor. (See Fig. 11)

6. Remove the compressor. 
7. Re-install the components by referring to the

removal procedures, above.

1. Remove the control box. (Refer to section 2.1.3)
2. Remove the 1 screw
3. Open the control box
4. Disconnect all the leads on the capacitor terminals.
5. Re-install the components by referring to the

removal procedures, above.