Fujitsu AWU24RXQ Manuale Utente

Fig. 1 Indoor Unit

1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button

3 Remote Control Signal Receiver

4 Indicator Lamps (Fig. 3)
5 OPERATION Indicator Lamp

(green ...... COOL, DRY, FAN)

(red .......... *HEAT)

6 TIMER Indicator Lamp (yellow)
7 SWING Indicator Lamp (orange)

(VERTICAL/HORIZONTAL SWING)

8 AIR CLEAN Indicator Lamp (green)

●

If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting

(See page 19 Auto Restart).

9 Intake Filter (Fig. 4)
; UP/DOWN Air Direction Flaps
A RIGHT/LEFT Air Direction Louvers

(behind UP/DOWN Air Direction Flaps)

B Drain Hose
C Electronic Air Clean Unit (Fig. 4)

Fig. 5 Outdoor Unit

D Intake Port
E Outlet Port
F Pipe Unit

Fig. 6 Remote Control Unit

G AIR CLEAN button
H MASTER CONTROL button
I SET TEMP./SET TIME buttons (

)

J Signal Transmitter
K TIMER button
L FAN CONTROL button
M START/STOP button
N AIR FLOW DIRECTION

VERTICAL SET button

O AIR FLOW DIRECTION

VERTICAL SWING button

P AIR FLOW DIRECTION

HORIZONTAL SET button

Q AIR FLOW DIRECTION

HORIZONTAL SWING button

R TIME ADJUST button
S ACL button

Rear side (Fig. 7)

T TEST RUN

● Touch the two metal contacts with a me-

tallic object to send the signal to perform
a test run.

● Perform a test run only when installing the

air conditioner. If the signal to perform a
test run is received during normal opera-
tion, the air conditioner’s thermostat will
malfunction.

● If the signal to perform a test run is re-

ceived during normal operation, the unit
will switch to the test operation mode and
the indoor unit’s OPERATION and TIMER
indicator lamps will flash simultaneously.

● To stop the test operation mode, press the

START/STOP button to stop the air condi-
tioner.

U Remote Control Unit Display (Fig. 8)
V Transmit Indicator
W Clock Display
X Operating Mode Display
Y T imer Mode Display
Z Fan Speed Display
[ Temperature Set Display
\ T imer Set Indicator
] Temperature Set Indicator