Toshiba R410A Manuale Utente

86

• For installation of the filter, refer to

the rear side of this manual.

• Keep this Manual with Owner’s

Manual.

• Before installation work, read thoroughly this “Safety Cautions” to install the air conditioner correctly.

• This “Safety Cautions” describes the important contents concerned to the safety. Be sure to keep in mind these items.

Symbols and meanings are as described below.

Indicates “User may be dead or seriously injured (*1) if it is incorrectly used.”

Indicates “It is assumed that user may be injured (*2) or property damage (*3) may occur if it is
incorrectly used.”

*1: “Serious injury” means a disease which has an after-effect or requires hospitalization or long-term going to the hospital for

treatment, such as loss of sight, burn (by high temperature or low temperature), electric shock, fracture, poisoning, etc.

*2: “Injury” means hurt, burn, electric shock, etc. which does not require hospitalization or long-term going to the hospital for

treatment.

*3: “Property damage” means enlarged damage concerned to house, household effects, domestic animal, pet, etc.

  indicates prohibition (prohibited action).

The concrete prohibited action is indicated with picture or sentence in or near the picture symbol.

  indicates that the forced instructed action (Act necessarily).

The concrete instructed action is indicated with picture or sentence in or near the picture symbol.

  indicates an item with care.

The concrete item to be cautioned is indicated with picture or sentence in or near the picture symbol.

 

• Do not put a plastic bag including filter on a place where

hands of a small child can reach.
If the child puts the bag on his head, it may seal
his mouth or nose resulting in choke of death.

• Install the suction grille surely to the main unit.

If an incomplete installation is performed,
falling of the suction grille causes an injury.

High-efficiency filter
(65%) model name

Conformed air
conditioner model name

Quantity

Dust collecting effect

Operation time

1101BT

—

561BT

801BT

to

1401BT

1

1

2

2

Color test 65%

2500 hours

High-efficiency filter
(90%) model name

Conformed air
conditioner model name

Quantity

Dust collecting effect

Operation time

1101BT

—

561BT

801BT

to

1401BT

1

1

2

2

Color test 90%

1800 hours

Remove the air filter, and install high-efficiency filter to the
suction port.
Push the high-efficiency filter completely up to the end.
Check that the rear side is hanged to the hook.

Install the air filter
Be sure to fix the air filter with clamps in order to prevent falling.
(Clamps are attached to the indoor unit.)

These filter cannot be reused even if it is washed.

To install a filter sold separately, be sure to set the fan referring the following description.
* The filter sold separately cannot be installed to an air conditioner built in with auxiliary electric heater.

Necessary at initial installation only

Two methods are provided for setup, one is to use a wired remote controller sold separately
and the other is to exchange the short plug on the indoor microcomputer P.C. board.

0000

0001

Standard filter (At shipment)

High-efficiency filter (65%)
(TCB-UFM11BE to UFM41BE)
High-efficiency filter (90%)
(TCB-UFH51BE to UFH81BE)

* Setup can be performed only by the

wired remote controller. If setup is not
performed, air volume is decreased and
dewing occurs.

(Procedure) Perform the setup while the equipment stops.

SET

 + 

CL

 buttons concurrently for 4 seconds or more.

The firstly displayed unit No. is the master indoor unit address of the group control.
In this time, the fan of the selected indoor unit only operates.

UNIT

order.
In this time, the fan of the selected indoor unit only operates.

For contents of the setup data, refer to the table at the right.

SET

Short plug position (CN112, CN111, CN110 from the left)

To exchange the static pressure, there is a method other than the
abovementioned method by wired remote controller, which is to shift the
short plug on the indoor microcomputer P.C. board as shown in the
following table. Adopt this method in case of using a wireless remote
controller, etc.
* However, after exchanging once, be careful to shift the short plug to the

standard position (At shipment) in order to return to the standard setup
(follow to E

2

PROM setup) though the setup for high static-pressure 1,

high static-pressure 2, or low static-pressure can be arbitrarily performed.
It is necessary to rewrite data from the wired remote controller sold
separately in the set data “0000”.

*1 Resistance of high-

efficiency filter 65 and
90, deodorant filter, or
ammonium filter is
equivalent to 30Pa.
Therefore, set the
resistance (external
static pressure) of a duct
to be connected to 40Pa.

Air filter

High-efficiency 
filter

High-efficiency 
filter

Hook

Indoor unit

Short plug position

40Pa

Standard
(At shipment)

70Pa

High static-
pressure 1

100Pa

High static-
pressure 2

20Pa

Low static-
pressure

Standard filter
(At shipment)

Zeolite-3G deodorant filter

*1
High-efficiency filter 65
High-efficiency filter 90
Deodorant filter
Ammonium filter

——

——

Short

CN112 CN111 CN110

Open

CN112 CN111 CN110

CN112 CN111 CN110

CN112 CN111 CN110

UNIT

SET

CL

SETTING

UNIT No.

CODE No.

SET DATA

R.C.

No.

UFBE-E