Haier FCD JTHA80- ET Manuale Utente

Setting Environment

² »

Ò ª

° ²

× °

Ó Ú

Î Þ

· ¨

Å Å

Ë ®

µ Ä

µ Ø

· ½

Description of the Symbols

Do not set it at place where is too cold and

may freeze.

Do not set at outdoor places.

Do not use as floorstanding appliance.

Please mount it to firm and reliable wall.

Do not install to places without sewer.

In case connecting water heater with water drain

hose, connect the drain hose to the inlet of the

sewer to avoid polluting by splashing.

The original pipeline of the water heater is an organic part of "Safe Care". Do not remove it by yourself.

Otherwise we will not take responsibility for the injure and loss caused by the safety trouble occurred

therefrom.

Never do that

Be sure to act as per instructions

Installation

Connection and use of safety valve:

The safety valve should be connected to the cold water inlet pipe. Please check

carefully if the direction is correct after installation. The correct direction of installation

is that the arrowhead on the safety valve should point to the water heater.

Please connect the drain hose to the safety valve. Connect one end of the hose to the

safety valve vent and the other end to the sewage drain. The hose can be cut short or

extended as necessary. The hose shall be installed as inclined downward.(see to

Figure 4)

(Figure 3) for reference in installation only

Cold water inlet

Mixing valve

Hot water
outlet valve

Cold water
outlet valve

Shower head

Hot
water
outlet

Safety valve

Installation must be made by installers of or designated by our company after-service

department. The water heatershall be wall-mounted.

Before installation, make sure water heater rear wires are fit firmly. Determine an

installation location. Make four holes

12mm, 65 mm deep in the wall with an impact

drill according to installating dimension. Insert fixexpansion hooks and expansion bolts

in corresponding wall holes. Lift the water heater. Insert wall rack onto the hooks and

bolts. Fit flat washers, rear wires and nuts in turn onto the bolts (see Figure 2). Tighten

the nuts and check them firm. Install accessories such as safety valve, drain hose as

shown in Figure 3. Use sealing compound to prevent water leakage.

(Figure 2)

To facilitate installation and removal, it is suggested a G 1/2" movable nut is fitted at

appropriate locations on inlet and outlet pipes respectively. Find water supply location.

Connect inlet pipe, outlet pipe and city water pipe respectively to the use point.

The hot water pipe shall not be too long to reduce the heat losses.

Please reserve some space in installation for the future maintenance.