Roberts Radio R9929 Manuale Utente

When your radio is first connected  to a power supply (batteries or mains)
or after a power failure (when backup batteries are not installed), the
Auto setup will proceed as follows:-

• Automatically search all wavebands and store stations in
  presets.
• Automatically set the time and day of week.

1. Install batteries or connect to mains (see page 6). Your radio will

show "SEARCHING FM PLEASE WAIT' followed by a Demonstra-
tion of the RDS features available.

2. Your radio is ready for use when the Auto Time indicator 

 stops

flashing.

3. The auto time indicator 

 will flash in the display whilst time setting

is carried out.

4. If the first station detected by the automatic setup does not carry

Clock  Time information your radio will automatically change to
another station after 1-2 minutes. This process will repeat until the
clock is set.

5. Press the Power  button to switch on your radio and press one of  the

Preset buttons to select a station. Adjust the volume using the
Volume control. To switch off your radio press the Power button.
Note:- Auto setup can take up to 5 minutes to complete and is
dependent on the signal strength and number of stations in your
area.
To interrupt the Auto setup press and release the Memo button.
Should Auto setup fail, setting the clock and pre-setting stations can
be carried out manually as described in the following sections.

2