Kramer Electronics VM-5ARII Manuale Utente

 

This section describes how to connect the: 

• 

Video Audio Distribution Amplifier, see 

Section  6.1

• 

1:20 Programmable Video Audio Distributor, see 

Section  6.2

 

Always switch off the power to each device before connecting it to your 
VM-5ARII/VM-20ARII

. After connecting your VM-5ARII/VM-20ARII, 

connect its power and then switch on the power to each device. 

To connect the VM-5ARII, as shown in the example in 

, do the following: 

1.  Connect the input video source (for example, a composite video player) to 

the VIDEO INPUT BNC connector. 

2.  Connect the input audio source (for example, the audio from a composite 

video player) to the AUDIO IN RCA connectors noting the right and left 

channels. 

3.  Connect the VIDEO OUT 1 to 5 BNC connectors to up to 5 acceptors (for 

example, composite video recorders).  

You are not required to connect two acceptors. 

4.  Connect the AUDIO OUT 1 to 5 RCA connectors to up to 5 acceptors (for 

example, the audio input on the composite video recorders). 

You are not required to connect two acceptors.  

5.  If needed, connect the VIDEO LOOP BNC connector to an acceptor (for 

example, a composite video display or another VM-5ARII) and set the 

termination pushbutton to 75Ω.  

6.  Connect the power cord to the unit (not shown in the illustration) and then to 

the mains electricity. Switch on the power. 

Use the power cord supplied with the unit.