Atlas Sound GST-G Dépliant

TELEPHONE: (800) 876-3333

FAX (800) 765-3435

©20

10 

Atlas S

ound L

.P.  

All rights reserved.  

Atlas S

ound is a trademark of 

Atlas S

ound L

.P.  

All other trademarks are the proper

ty of their respecti

ve owner

s.  

All specs are subject to c

hange without notice.  

ATS0

02960 R

evE 7/1

2

1601 JACK MCKAY BLVD.  

ENNIS, TEXAS 75119  U.S.A.

•

Downward Firing Speaker Will Not Collect Dust or Condensation

•

Rugged Construction Can Support Up To 250 lbs

•

Easy Bayonet Attachment of Head Unit To Base, Enables Installation
of Base During Excavation and Installation of Head Unit After
Landscaping Has Been Completed

•

Switch Selectable 70V Input or Direct 8Ω Input (Transformer Bypass)

•

Easy Conduit Installation in Tall and Short Base With Dedicated
Mounting Pads

•

Speaker Protected By Triple Layer Grille

•

Short Base (GSS-G) has Drill Points for 4" Square, 2-Gang EO Box, or
1-Gang Box Mounting to a Deck or Slab

1.   Make sure you have a path to bury wire connected to speaker.

2.   Dig a hole 8" deep x 30" diameter.

3.   Run wire to hole.

4.   Attach conduit or gland nut to flats on base.

5.   Bring in wire and leave sufficient cable for adequate service loop

(minimum 18") to reach head unit.

6.   Fill base with clean dirt or sand to within 2"-3" of top for optimum

bass performance.

7.   Cover with provided temporary lid and attach with provided

1" screws if head unit is not to be attached immediately.

8.   Back fill dirt to base. Top of base should be 2" – 3" above ground.

1.   Install 1-Gang, 2-Gang, or 4" x 4" box flush to mounting surface.

2.   Cut out scribed line on bottom of base for 1- or 2-gang box.

3.   Drill appropriate holes in base (outer 4 holes for 4" x 4", inner 4 for

2-gang, or 1 set of 2 inner for 1-gang).

4.   Install wiring in box.

5.   Set base on box and attach with screws.

1.   Mount base to surface with appropriate screws through the base

bottom.

2.   Attach conduit and bring in wire. Provide for surface loop

(minimum 18").

3.   Cover with provided temporary lid and attach with provided 1" screws

if head unit is not to be attached immediately.