Honeywell HD28W4HR6 Manuale Utente
Rev 1.01
4
Document 900.0275
10/05
Wiring Options
Your HD28 Series camera is supplied with a coaxial termination board mounted
to the bottom of the enclosure. All connections are made here (see
to the bottom of the enclosure. All connections are made here (see
).
Figure 3
Wiring Options
Connecting the Wiring
1.
Pull the cables through either the back or the side conduit.
2.
To minimize moisture leaking into the housing, position the enclosure with
the conduit pointing down. Apply an appropriate sealant around the conduit
connection.
the conduit pointing down. Apply an appropriate sealant around the conduit
connection.
Adjusting the Camera
To adjust the HD28 camera:
1.
Apply 12 VDC or 24 VAC to the camera and monitor the video signal.
2.
Loosen the screws that lock the gimbal assembly in place (see
).
3.
Adjust the camera carrier to the desired view (see
4.
Tighten the screws to lock the gimbal assembly in place.
Note
Orient the camera as shown in
to maintain the correct
picture orientation.
Coax Termination Board
Case/
Ground
Ground
Not used
Power
Audio
Video