Toshiba IKWB30A Manuale Utente

13

Follow the steps below to mount the Network Camera:

The Installation example is for reference only. Mounting bracket is not included.

1. Drill six pilot holes (φ0.24 inch x 0.37 inches(D)). And Hammer the plastic 

anchors (not included) into the holes.

2. Align the six holes of the mounting Bracket (not supplied) with the six plastic 

anchors, insert the appropriate screws (φ0.16 inch x 0.96 inches(D)) (not 
included) to corresponding holes.

3. Secure the Mounting Bracket to the wall.

4. Mounting the Lens to the camera. Use the appropriate lens (not supplied).

5. Turn the camera to the desired position when install the camera to the Mounting 

Bracket. And secure using a screw driver.

 Since this camera is using a 2 megapixel sensor, the recommended lens is a 2 

megapixel lens for 1/3 inch sensors.

 Do not block the light sensor when using an auto iris lens.
 When installing in high locations, take caution to secure the camera from falling and 

causing possible injury.

 Tie using Fixing Hole to prevent from unplugging of power cord or other 

cable.

112 (4.41)

15 (0.59)

Wall

9.5 (0.37)

4 (0.16)

͝

6 (0.24)

80 (3.15)

1/4"-20UNC

m m ( i n c h )