Jonsered GC 2125C Manuale Utente
12 –
English
ASSEMBLY
Assembling and dismantling the
two-piece shaft
two-piece shaft
(GC 2125C)
Assembly:
•
Loosen the coupling by turning the knob.
•
Align the tab of the attachment (A) with the arrow on the
coupling (B).
coupling (B).
•
Push the attachment into the coupling until the attachment
snaps into place.
snaps into place.
•
Before using the unit, tighten the knob securely.
Dismantling:
•
Loosen the coupling by turning the knob (at least 3 times).
•
Push and hold the button (C). While securely holding the
engine end, pull the attachment straight out of the
coupling.
engine end, pull the attachment straight out of the
coupling.
Assembling the cutting equipment
Fitting the trimmer guard and Auto
32 trimmer head
32 trimmer head
(GC 2125, GC 2125C)
•
Fit the correct trimmer guard (A) for use with the trimmer
head. Hook the guard onto the fitting on the shaft and
secure it with the bolt (L).
head. Hook the guard onto the fitting on the shaft and
secure it with the bolt (L).
•
Fit the drive disc (B) on the output shaft.
•
Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
aligns with the corresponding hole in the gear housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
To fit the trimmer head, first separate the two halves (see
diagram). Proceed as follows:
diagram). Proceed as follows:
A
B
C
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.
!
WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
IMPORTANT! If a saw blade or grass blade are to be used
the machine must be equipped with the correct handlebar,
blade guard and harness.
the machine must be equipped with the correct handlebar,
blade guard and harness.
G
F
I
A
B
C
K
J
I
K
L