Shindaiwa X7502831600 Manuale Utente

6

Handlebar and Throttle assembly

Ŷ

Use the 4 mm hex wrench to remove the 

1.

lower cap retaining screws from the 

handlebar bracket. Remove the cap 

from the bracket.
Position the handle on the outer tube for-

2.

ward of Handle Positioning Label as 

shown. Reassemble the lower cap to the 

handlebar bracket in the reverse order 

of disassembly.
Locate the handle in the best position for 

3.

operator comfort.
Firmly tighten both lower cap retaining 

4.

screws.
Secure the cable to the outer pipe with the 

5.

2 bands as the illustration shows. The 2 

bands are in the tool bag.

6

This unit comes fully assembled with the 

exception of the cutting attachment shield 

and cutting attachment.

Before assembling, make sure you have all 

the components required for a complete 

unit and inspect unit and components for 

any damage.

Engine and shaft assembly

Ŷ

Cutting attachment shield

Ŷ

Cutting attachment

Ŷ

Kit containing cutting attachment 

Ŷ

shield, mounting bracket and hardware, 

this owner’s/operator’s manual and tool 

kit for routine maintenance. Tool kits 

vary by model and may include a spark 

plug/screwdriver combination wrench, 

and a scraper.

The terms “left”, “left-hand”, and “LH”; 

“right”, “right-hand”, and “RH”; “front” and 

“rear” refer to directions as viewed by the 

operator during normal  operation.

This unit comes fully assembled with the 

exception of the cutting attachment shield 

and cutting attachment.

Before assembling, make sure you 

have all the components required for 

a complete unit and inspect unit and 

components for any damage.

Engine/Outer tube assembly

 

■

Handlebar and Throttle assembly

 

■

Cutting attachment shields

 

■

This unit comes fully assembled with 

the exception of the handlebar, cut-

ting attachment shield and cutting 

attachment.

Cutting Attachment

 

■

Shoulder Strap w/Hip Pad

 

■

Cutting attachment shield mounting 

 

■

brackets and assembly hardware 

Cutting attachment adapter plates 

 

■

4 mm hex key wrench (Also use as 

 

■

a locking tool) 

T-wrench 

 

■

The terms “left”, “left-hand”, and 

“LH”; “right”, “right-hand”, and “RH”; 

“front” and “rear” refer to directions as 

viewed by the operator during normal 

operation. 

An Emission Control Label is located on the unit.  (This is an EXAMPLE ONLY; information on label varies by en-

gine FAMILY).

The 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine 

emissions output meets applicable emissions regulations, provided that approved maintenance procedures are 

followed as listed in the Maintenance Section of this manual.

The emission control system for the engine is EM/TWC (Engine Modification and 3-way Catalyst) and for the fuel tank 

the Control System is EVAP (Evaporative Emissions) or N (for nylon tank). Evaporative emission may be applicable to 

California models only.

Remove four (4) upper cap retaining 

1. 

screws, and remove upper cap from 

handlebar mounting bracket.
Place handlebar on mounting 

2. 

bracket, and secure with upper cap 

and four (4) screws.
Adjust handlebar position for best 

3. 

operator comfort and control, then 

tighten upper and lower cap retain-

ing screws securely.
Secure cable to outer tube with two 

4. 

(2) bands provided.