HTC Z4824BF Manuale Utente

English

-44

MAINTENANCE

To replace EZT (E-Series Zero Turn Transaxle) belt
Park the mower on a level surface. Engage the 

parking brake.

EZT belt removal
NOTE: Be careful not to damage the fan blades on the 

EZT´s as this can affect cooling or damage the EZT´s
• Remove the deck belt (see to replace deck belt in 

this section of the manual).
• Unplug clutch from wiring harness. Remove bolt from 

center of clutch and slide clutch off of engine shaft.
• Create slack in the belt by removing the spring on the 

pump idler arm.
• The belt should now be able to be removed from the 

engine pulley and EZT pulleys.

Belt installation
•   Wrap the EZT belt around the EZT pulleys
•   Route the belt around the inside of the idler pulley.
•   Now you can wrap the belt around the engine 

pulley.

•   Reattach the spring on the pump idler arm.
•   Install clutch on to engine shaft (pulley side down) 

make sure key is installed and align the clutch 

anti-rotation tab into slot on clutch. Secure clutch, 

install wire.

•   Reinstall the deck belt onto the electric clutch belt 

(see to replace deck belt in this section of the 

manual).